02-09-2012 11:56 AM
I used to connect my labtop to the router in wireless. Last night, i was trying to connect it in cable. After i connect the cable to my labtop internet port and the router ethernet port, it doesn't show up anything. It should have light beside the port. What can i do ?
02-10-2012 09:30 AM
Could be a bad cable or the ethernet port might be disabled.
To enable the ethernet port, you need to go into the command prompt and open up the device manager and enable or reload the ethernet port.
02-10-2012 09:12 PM - edited 02-10-2012 09:15 PM
To run the ipconfig /all try:
1.Click on Start > and type "cmd" in the Search box.
2.At the Blinking Cursor, type "ipconfig /all" and hit enter.
3.Use your mouse and Highlight the information from step 2 and hit enter (This will copy the info to your clipboard)
4.Open up a new post here in your thread and use ctrl v or rightclick and paste the information into the post
This will give some information so we can see why your Laptop is not connecting.
©2011 Comcast | Investor Relations | Press Room | Corporate Blog | Privacy Statement | Visitor Agreement | Comcast.com Feedback | Site Map